ARMAT by Alba Racing 4 Layer Silicone Charge Tube for RZR Turbo !!

Our Boost Tube for the RZR Turbo is 30% larger diameter than stock. This helps with front side power, we have seen a 2.5-3 hp increase on the front side of the dyno curve when paired with our J-tube. It has provisions for a vent to atmosphere BOV (blow off valve), factory map sensor, and pressure port for a boost gauge. Made from 4 layer “High Pressure” Silicone, it will not collapse or burst. We have pressure tested these in the shop up to 50 PSI. Not only will our charge tubes handle extreme pressure because they are made out of silicone, they also have an extremely low thermal conductivity. AKA they do not transfer heat! Also silicone allows for a better seal at the Throttle Body, BOV and Turbo compared to stock rubber.

Features:
- 30% larger diameter
- Increases front side power +2.5-3HP
- Factory fit and sensor location
- 4 Layer High Pressure Silicone
- Tested to 50 PSI
- No heat soak